Radio Systems Radio Fence Plus Remote Trainer, Руководство пользователя

Страница: 7 / 24

THE REMOTE TRANSMITTER
Installing the batteries in the remote
transmitter
The transmitter takes one (1) 9-Volt alkaline
battery. To install the battery, follow the
instructions listed below:
• Place your finger on top of the "Pull" area of
the battery door, located on the backside of
the transmitter.
• Remove the battery door by lifting your finger.
• Connect the battery and replace the
battery door by placing the bottom
side of the battery door in first.
Testing the remote transmitter
The light at the top of the remote transmitter
should light up when any button is pressed.
Also, the containment transmitter will
beep when it receives the signal from the remote
transmitter. For initial testing,
stand within ten feet of the containment
transmitter and press the "PROGRAM" and
the " + " buttons at the same time on the remote transmitter. Then press the " "
button. If the containment transmitter beeps, the remote transmitter is working correctly. The containment
transmitter must be turned on with the boundary wire properly connected, and the antenna positioned
vertically.
Burying the wire
Burying the wire is recommended to help prevent
damage to the wire and to help avoid possible
injuries to persons tripping over the exposed wire.
Cut a trench one to three inches deep along your
previously planned boundary. This may be done with
a flat edge spade or a lawn edger. With a paint stick
or equivalent, press the wire firmly into the grove. You
may also consider renting a machine that is designed
to cut a shallow trench and bury the wire.
Be sure to maintain some slack. The wire will expand and contract with temperature variations.
Crossing hard surfaces
If you have to cross a hard surface,
such as concrete, lay the wire in a
convenient expansion joint or use a
circular saw with a masonry blade
to create a groove. Again with a
paint stick or equivalent place the
wire in the groove and cover with
an appropriate patching compound.
Your local hardware store can help
you choose the right compound for
your type of driveway.
Setting the boundary
Adjust the signal range adjustment knob to set the warning zone at a range that is best for your yard. We
recommend a minimum range of five feet on either side of the wire. It is best to have as wide a signal area
Pull Area battery door must be lifted
up in order to insert the battery.
5