10
11
Get Ready to Fly
1.
Plug the drone battery into the socket, insert the battery
and its cable into the battery compartment, and secure the
compartment door.
2.
Turn on the drone. The LEDs under the arms and on top of the
body flash.
3.
Place the drone on level ground.
4.
Set the remote control’s
ON/OFF/Special
switch to
ON
. The
remote control's LED flashes.
5.
Move the throttle all the way up and then down to pair the
remote control with the drone. The drone’s blades remain still
during pairing. When paired, all LEDs on both the remote control
and drone stop flashing and light steadily.
Note:
If pairing fails, turn off the drone and remote control and repeat
the steps above, or change locations to avoid electrical interference.
2
1
Screw
Fly Your Drone
1.
With the drone on the ground, move the throttle forward to fly.
2.
To land your drone, slowly move the throttle backward to
descend. Avoid moving the throttle too quickly, as it can stop the
blades instantly and cause the drone to crash.
3.
When you finish flying the drone, turn off the remote control and
drone. Disconnect and remove the drone battery.
Trim Your Drone
Push the throttle forward and observe how the drone reacts.
Forward/Reverse Movement Trim:
If the drone tends to move
forward, press
6
; if it tends to move backward, press
5
.
Left/Right Slide Trim:
If the drone tends to slide right, press
3
; if it
tends to slide left, press
4
.
Left/Right Turning Trim:
If the drone tends to turn right, press
3
; if
it tends to turn left, press
4
.
Note:
The remote control beeps when you press a trim control but
stops beeping when you reach maximum trim adjustment.
Flying in Special Mode: True-North
Featuring integrated True-North compass, the drone can
automatically align with your remote control, which can let beginners
experience much easier flight control.
1.
Align the drone and remote control in the same direction.
2.
Set the remote control’s
ON/OFF/Special
switch to
Special
,
then turn on the drone. LEDs flash.
3.
To pair the remote control with the drone, move the throttle all
the way up and then down. When paired, LEDs on the remote
control and the drone’s four arms stop flashing and light steadily,
while the two body LEDs
flash slowly.
4.
After pairing, move the throttle to fly. Drone will fly in any
direction based on steering.
6001352_UG_EN_030315.indd 10-11
3/3/2015 2:52:39 PM
