25
3. When you finish your message,
press
STOP/7
. The TAD beeps,
plays back the message, then
beeps again.
Note: If your message is less than 2
seconds, the TAD does not recognize
it as a new message, and plays back
the previous pre-recorded message.
Re-record your message and make
sure it is longer than 2 seconds.
To delete your personal message and
use the pre-recorded messages
again, hold down
OGM REC/8
for about
2 seconds until the TAD beeps. Then,
within 2 seconds, press
STOP/7
.
SETTING THE TAD TO
ANSWER CALLS
To set the TAD to answer calls, press
ANSWER
on the base. The number of
calls in the TAD’s memory (or
0
) ap-
pears on the display if you set the
TAD to announce and record, or
A
ap-
pears if you set it to announce only.
You can also set the TAD from the
handset. Press
REMOTE
so the BATT
LOW indicator lights green. After the
TAD announces the current outgoing
message (either a pre-recorded mes-
sage or your personal message),
press
ANSWER/6
to set the TAD to an-
swer calls.
Notes:
• If the incoming message memory
capacity has less than 5 minutes
left, the TAD announces “Remain-
ing time, xx minute(s)” when you
set the TAD to answer calls.
• If the incoming message memory
capacity is full (40 messages or
less than 1 minute left), the TAD
announces “No remaining time for
incoming messages” and does not
let you set it to answer calls.
To turn off the TAD, press
ANSWER/6
on the handset or
ANSWER
on the
base.
43-775.fm Page 25 Friday, August 13, 1999 3:25 PM
