8
Beyond the Basics
9
Beyond the Basics
important information
care and maintenance
To clean the surface of the unit, simply wipe with a
soft, clean cloth moistened with plain lukewarm water.
To clean the tape heads, pinch the rollers and capstans,
and wipe using a cotton swab moistened with alcohol or
head-cleaning fl uid.
To clean the cassette deck, use a soft, clean moistened
cloth. Never use chemical cleaners or let liquid inside the
unit.
Handle your CD/CDGs with care.
If fi ngerprints, dust or dirt appear on your CD/CDGs, wipe
with a damp cloth in straight lines from the center to the
edge. Do not use detergents or abrasive cleaning agents.
warnings and cautions
The normal ventilation of this product shall not be impeded
for intended use.
This CD player is made and tested to meet exact safety
standards. It meets FCC requirements and complies with
the safety performance standards of the U.S. Department of
Health and Human Services.
This CD player uses a laser light beam. Only qualifi ed
service personnel should remove the cover or attempt to
service this device, due to possible eye injury.
The use of controls, adjustments, or procedures other
than those specifi ed herein might result in hazardous
radiation exposure.
The CD player is classifi ed as a Class 1 Laser product. The
label is located on the rear panel.
Invisible laser radiation when open. Avoid exposure to
beam.
The CD player shall be used only in an open area.
time display selection
Repeatedly press
DISPLAY
on your remote during normal play. You
will see REMAIN, TOTAL, REMAIN TOTAL on the top left side of the
display.
REMAIN - Remaining playing time for the current track
TOTAL - Elapsed playing time for the disc
REMAIN TOTAL - Total remaining playing time for the disc
program play
You can program up to 32 selections on up to three discs for play in
any order.
To begin the programming procedure, select the “CD” mode.
Press
PROGRAM
and select
DISC SELECT
or
DISC SKIP
to
select the desired disc, in CD player stop mode.
Press
SKIP
or the number button on the remote control to
select the desired track. P-01 will appear.
Press
PROGRAM
to store the selected track.
Repeat steps 2-4 to program up to 32 tracks.
Press
PLAY/PAUSE
to play the programmed tracks.
To review the programmed tracks, press
PROGRAM
repeatedly, in CD player stop mode.
To replace the number of the tracks you want, press
PROGRAM
repeatedly until the desired track appears, and
repeat steps 3-4 to select and store the new track.
To erase a programmed sequence at any time, press
OPEN/CLOSE
, or press
STOP after you stop the playing
.
Note
The displayed playing times may differ slightly
from the times listed on the notes accompanying
the disc.
Notes
The same disc or track can be programmed more
than once.
Load the disc that you want to program before
starting programmed play.
