13
VCR SETUP
SETTING THE VCR’S OUTPUT
CHANNEL SWITCH
If you connected the VCR’s
OUT TO TV
termi-
nal to a TV or another VCR, set
3-CH-4
on the
back of the VCR to
3
or
4
, whichever is not an
active channel in your area.
When VCR appears on the display, the VCR
sends the signal from the video source con-
nected to its
IN FROM ANT.
or
R-AUDIO-L IN 1/
VIDEO IN 1
(or
AV2
on the front panel) terminals
to the TV on the channel you selected.
Note: Setting
3-CH-4
has no effect on the TV
when the VCR is off or if you connected a TV
with separate audio/video input jacks to the
VCR’s
R-AUDIO-L/VIDEO OUT
jacks.
REMOTE CONTROL
Installing Batteries
The remote control requires two AA batteries
(not supplied). For the longest operation and
best performance, we recommend alkaline bat-
teries (such as RadioShack Cat. No. 23-557).
Cautions:
• Use only fresh batteries of the required
size and recommended type.
• Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
1. Press the tab on the battery compartment
cover and lift off the cover in the direction
of the arrow.
2. Put fresh batteries in the compartment as
indicated by the polarity symbols (+ and –)
marked inside.
3. Replace the cover.
Note: When the remote control stops working
or operates poorly, replace both batteries.
Cautions:
• Never leave dead or weak batteries in the
remote control. Batteries can leak chemi-
cals that can damage your remote control.
• Dispose of dead batteries promptly and
properly; do not bury or burn them.
Using the Remote Control
To use the remote control, aim it at the front of
the VCR and press the desired function but-
tons.
Tab
+
16-634.fm Page 13 Tuesday, July 20, 1999 5:37 PM
