11
MOUNTING THE BASE
DIRECTLY ON THE WALL
For this mounting method, you need two
flat-head screws (not supplied) with
heads that fit into the keyhole slots on the
bottom of the base.
1. Drill two holes 3
15
/
16
inches (100 mm) apart.
Then thread a screw
into each hole, letting
the heads extend
about
5
/
16
inch (7 mm)
from the wall.
2. Remove the bracket by holding in
both tabs and gently pulling out the
wide end of the bracket.
3. Plug one end of the supplied long
modular cord into the phone jack on
the back of the base.
5
/
16
3
15
/
16
4. Insert the supplied power adapter’s
barrel plug into the
DC 12V
jack on
the back of the base.
5. Route the modular cord through ei-
ther groove on the bottom of the
base and the adapter cord through
the groove below the strain relief
slot.
43-1021.fm Page 11 Tuesday, August 17, 1999 9:14 AM
