MOUNTING THE PHONE
Desk Mounting
Wall Mounting
(With or Without Wall Plate)
ÐÐ
Set the volume for each line’s
ringer. Set to
HI
in a noisy
room or
LO
in a quiet room.
To turn off the ringer, set it to
OFF
. You can still make calls
with the ringer off, and you
can also receive calls, if you
hear another phone on the
same line ring.
Set to
TONE
or
PULSE
to match the
type of service you
have.
If you have pulse
(rotary) service, you
can switch to
TONE
during a call to use
tone services.
Use a paper clip or other
pointed object to lift the plastic
cover off the number plate.
Then write your phone num-
ber(s) on the number plate and
replace the cover.
Note: Use a pencil in case the
number changes.
Press
REDIAL
to dial the
last number dialed (up to
31 tone or 32 pulse dig-
its).
Press
HOLD
to place a call on
hold. When the line’s red indi-
cator lights, you can place the
handset on the cradle. To return
to the call, press that line’s but-
ton or pick up any extension
phone on that line.
Press
RESET
to end a
call without hanging up
the handset.
Adjust the handset’s vol-
ume as desired.
Plug the handset
cord into the jacks
on the base and
handset.
MAKING A CONFERENCE CALL
1. Place a call to one of the parties.
2. Press HOLD to put the first call on hold.
3. On the other phone line, place a call to the other
party.
4. After the second party answers, press
CONF
to
connect all three parties.
To talk on only one line without disconnecting the
other line, press
HOLD
to put both lines on hold. Then
press the button for the line you want to talk on. To
return to the three-way conversation, press
CONF
.
To disconnect one line and continue talking on the
other, press the button for the line you want to talk on.
The green indicator next to
LINE 1
or
LINE 2
lights to show
which line is ringing.
Use
CONF
to make a confer-
ence call. See “Making a Con-
ference Call.”
USING THE PHONE
This symbol is intended to inform you
that parts inside the telephone present
a risk of electric shock.
This symbol is intended to alert you to
important operating and servicing
instructions included in the papers with
the telephone.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note: The USOC number of the jack to be installed is
RJ11C or RC14C (RJ11W for a wall jack).
1997 Tandy Corporation. All Rights Reserved.
Radio Shack is a registered trademark used by Tandy Corporation.
Handset Holder
(Wall Mounting)
(Screws not supplied)
