ÐÐ
Press
REDIAL
to dial the last
number dialed (up to 32 digits).
Press the switchhook to
disconnect a call.
Press
FLASH
instead of the
switchhook for special services
such as Call Waiting.
Press
STORE
once before and after you
enter the phone number you want to store.
See “Storing/Dialing Numbers in Memory.”
Set to
LOW
,
MED
,
or
HI
to
adjust the handset volume
to a comfortable listening
level.
STORING/DIALING NUMBERS IN MEMORY
To store a number in memory:
1. Lift the handset and press
STORE
.
2. Enter the telephone number you want to store (up
to 16 digits).
Note: To enter a pause of about 4 seconds to
access a second dial tone, press
REDIAL
. Each
pause entry counts as one digit in memory.
3. Press
STORE
again.
4. Press
P1
,
P2
, or
P3
, then return the handset to the
cradle.
To dial a number in memory:
1. Lift the handset.
2. Press
P1
,
P2
, or
P3
.
Note: If you store an emergency service’s number (po-
lice, fire department, ambulance) and you want to test
the stored number, make the test call during the late
evening or early morning hours to avoid peak demand
periods. Also, remain on the line to explain the reason
for your call.
Set to
TONE
or
PULSE
to match
the type of service you have. If
you have pulse service, you can
move it to
TONE
(or press )
during a call to use tone ser-
vices, such bank-by-phone.
Handset cradle hook holds
handset in place when phone
is wall mounted. Use this hook
to hold the handset temporarily
without disconnecting a call.
Slide
RINGER VOL.
to adjust the
ringer volume to a comfortable
level.
Indicator lights when the handset is
off the hook.
Set
RINGER
to
1
,
2
, or
3
to adjust
the ringer’s tone.
USING THE PHONE
SET UP
This symbol is intended to alert you
that parts inside the telephone present
a risk of electric shock. Do not open
the case.
This symbol is intended to alert you to
important operating and servicing
instructions included in the papers with
the telephone.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note: The USOC number of the jack to be installed is
RJ11C (RJ11W for a wall plate jack).
1998 Tandy Corporation.
All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.
Plug the coiled handset cord into the jacks on the hand-
set and base.
Plug one end of the supplied long telephone line cord
into the jack on the back of the base. Plug the other end
into a modular phone jack.
As shown below, attach the mounting bracket based on
how you are mounting the phone.
If you mount the phone on the wall, press up on the
handset cradle hook to remove it. Then turn it over so its
tabbed edge faces up and press it back down into its slot.
Illustration
Illustration
Illustration
