4
The clock also automatically shows a
time zone to the left of the time. While
the clock is scanning for a signal, you
can set it (if necessary) to show your
time zone. To change the time zone, re-
peatedly press
ZONE
until the desired
time zone (
PACIFIC
,
MOUNTAIN
,
CENTRAL
, or
EAST
) appears.
Note: You must reset the time zone
each time you install batteries.
MOUNTING
You can place the clock on a flat surface
using the built-in stand, or mount it on a
wall using a screw (not supplied).
Selecting a Location
Choose an indoor location:
• where the clock will not be in direct
sunlight
• away from heat or cold sources
such as stoves, heating and air con-
ditioning vents, and radiators
• not near a TV, high power cable, or
metal table (because these could
interfere with radio signal reception)
Using the Stand
To set the clock on
a flat surface, pull
the built-in stand
away from the back
of the clock.
Mounting the Clock on a Wall
To mount the clock on a wall, you need
a
1
/
8
-inch (3-mm) screw (not supplied)
with a head that fits into the keyhole slot
on the back of the clock.
1. Drill a hole in the wall at the desired
mounting location.
2. Thread a screw into the wall until the
head extends about
1
/
4
inch from the
wall.
3. Position the keyhole slot over the
screw and slide the thermometer
down to secure it.
SETTING THE TIME
Automatic Time/Date Setting
The clock checks the radio signal six
times a day, at about 2:00 AM, 3:00 AM,
4:00 AM, 9:00 AM, 3:00 PM, and 9:00
PM (as shown on the clock). When the
clock receives a good signal, it automat-
ically sets the time and date.
Keyhole Slot
63-973.fm Page 4 Friday, January 7, 2000 7:45 AM
