3
4. If you want the keypad to sound tones when a day mode
zone is violated and the system is disarmed, set Switch 3
to
ON
. Otherwise, set it to
OFF
.
5. If you want the remote keypad to sound a tone during the
entry delay and sound an arming confirmation beep, set
Switch 4 to
ON
. Otherwise, set it to
OFF
.
6. Reconnect the control center’s backup batteries and AC
power.
Mounting the Remote Keypad
1. Place the template supplied with the control center at the
selected location. Then use a pencil to mark the locations
of the three keyholes.
2. Using screws and hardware appropriate for the mounting
surface, drive screws into the wall at the marked locations.
Let the screws’ heads extend about
1
/
4
inch from the wall.
3. Hang the remote keypad on the screws.
Testing the Remote Keypad
When you complete installation, check the system’s operation
to confirm that all functions work from all remote keypads. If a
keypad sounds unusual tones or is operating improperly, con-
firm that each remote keypad has a different address (see Step
3 of “Connecting the Remote Keypad to the Control Center”)
and that all wires are connected to the correct terminals.
49-484.fm Page 3 Thursday, August 19, 1999 8:42 AM
