9
On a Wall
To mount the System 999 directly on the
wall, you need two screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the base.
Note: Check for the proper viewing an-
gle of the liquid crystal display before
mounting this system to a wall.
1. Drill two holes, one above the other,
3
1
/
4
inches apart. Thread a screw
into each hole, letting the heads
extend about
1
/
8
inch from the wall.
2. Plug one end of the supplied long
modular phone cord into the
TEL.
LINE
jack on the phone.
3. Route the cord through the strain-
relief slot on the back of the phone.
4. Insert the tabs on the narrow end of
the stand into the matching slots
near the top of the phone, making
sure the cord is routed through the
opening in the stand. Snap the
stand into place by pressing in the
two tabs toward the bottom of the
phone.
5. Plug the other end of the modular
phone cord into a modular phone
jack.
6. Align the phone stand’s keyhole
slots with the screws and slide the
phone down until it snaps into place.
7. Slide out the handset holder, flip it
over as shown, then slide it back
into place.
1
/
8
"
3
1
/
4
"
Illustration,
connecting cord to phone
Illustration,
routing cord through strain-relief slot
Illustration,
attaching phone stand
Illustration,
mounting phone on screws
Illustration,
flipping handset holder
43-999.fm Page 9 Tuesday, August 17, 1999 8:28 AM
