22
Press
Command
Function
0
Stop
Stops message playback, recording, and room moni-
toring.
1
Play Outgoing
Message
If an outgoing message is recorded, the TAD says,
“Play announcement” and plays the outgoing mes-
sage. After the message plays, the TAD beeps once.
If no outgoing message is recorded, the TAD beeps
and announces, “No announcement.”
2
Change Outgoing
Message
Records a new outgoing message. When the TAD
beeps, announces “Record announcement,” and
beeps again, begin your new outgoing message.
When you finish, press 0
. The
TAD beeps.
3
Room Monitor
Monitors the room where the TAD is located. The TAD
announces “Room Monitor.” After 30 seconds, the
TAD beeps and monitoring stops. To stop monitoring
the room sooner, press 0
.
4
Play All Messages
(To see what com-
mands you can use
at this point, see the
table on Page 23.)
Plays all the recorded messages. When messages
are recorded, the TAD beeps, announces the number
of messages recorded, and plays the messages. If no
message is recorded, the TAD beeps and says, “No
message.”
5
Play New Messages
(To see what com-
mands you can use
at this point, see the
table on Page 23.)
Plays only new messages that have not already been
played. If new messages are recorded, the TAD
beeps, announces the number of new messages, and
plays them. If there are no new messages, the TAD
beeps and says, “No new message.”
6
Erase All Messages
If some messages (but no new messages) are
recorded, the TAD sounds 2 beeps and erases all
messages.
If new messages are recorded, the TAD beeps and
announces, “New messages” but does not erase all
messages.
If no messages are recorded, the TAD beeps and
announces, “No Message.”
43-744.fm Page 22 Friday, August 13, 1999 2:10 PM
