3
3. Route the adapter’s cord through the
strain relief slot on the base.
4. Plug the adapter into a standard AC out-
let.
5. Lift the base’s antenna to a vertical posi-
tion.
Mounting the Base on a Wall Plate
1. Plug one end of the
supplied short mod-
ular cord into the
TEL LINE
jack on
the back of the
base.
2. Route the modular cord through the right
slot on the bottom of the base.
3. Insert the supplied
AC adapter’s bar-
rel plug into the
DC IN 9V
jack on
the back of the
base.
4. Route the adapter’s cord through the left
side of the strain relief slot on top of the
base and through the left slots at the bot-
tom of the base.
5. Plug the short mod-
ular cord into the
wall plate jack,
press the excess
cord into the slot in
the center of the
base, then align the
base’s keyhole slots
with the wall plate studs and slide the
base down to secure it.
6. Press and lift out the handset holder, turn
it over and rotate it 180
°
, then snap it
back into place so it holds the handset.
7. Plug the adapter into a standard AC out-
let.
8. Lift the base’s antenna to a vertical posi-
tion.
Connecting and Charging
the Battery Pack
The phone comes with a rechargeable nickel-
cadmium battery pack in the handset. Before
using your phone, you must connect the bat-
tery pack and then charge it for about 24
hours.
1. Press down and slide the battery com-
partment cover in the direction of the
arrow to remove it.
2. Lift the battery pack out of the compart-
ment. Plug the battery pack’s connector
into the socket in the compartment. The
connector fits only one way.
3. Put the battery pack into the compart-
ment.
4. Replace the cover.
