6
Setup
Connecting an Antenna
There are many different types of CB radio antennas for mobile CBs. Each type
has its own benefits, so choose the one that best meets your needs.
Note: If you are using this CB as a base station, see
“Using the Transceiver
” on p.8.
Once you choose an antenna, follow its mounting instructions. Then route the
cable to the transceiver and connect the cable to the
ANTENNA
jack on the
back of the transceiver.
For the antenna’s best performance, you should mount the antenna:
•
as high as possible on the vehicle
•
as far as possible from sources of electrical noise
•
vertically
To take advantage of your CB’s maximum range, you can adjust the antenna’s
standing wave ratio (SWR) using an SWR meter (not supplied).
Follow the instructions supplied with the SWR meter and antenna to adjust your
antenna’s SWR to the lowest possible value. SWR values of 2.0:1 are generally
acceptable, with readings of 1.5:1 or lower being more desirable.
Cautions:
•
Avoid routing the cable next to sharp edges or moving parts, which might
damage the cable.
•
Do not run the cable next to power cables or other CB antenna cables.
•
Do not run the cable through the engine compartment or other areas that
produce extreme heat.
ANTENNA jack
EXT SPEAKER jack
