6
2. Loosen the screw with a screw driver and remove the panel on the bottom of both the
receiver and the transmitter units.
3. Use a pen or a pointed object such as a straightened paper clip to move the levers and
change the code on the transmitter.
4. Use a pen or a pointed object such as a straightened paper clip to move the levers and set
the same code on the receiver. Put the panel back on and tighten the screw before
plugging the transmitter and receiver into the AC power source. Plug in and power on the
transmitter, and then plug in and power on the receiver to make sure the system is working
properly.
CARE
Keep the transmitter and receiver dry; if either unit gets wet, wipe it dry immediately. Use and
store the transmitter and receiver only in normal temperature environments. Handle them
carefully; do not drop them. Keep the transmitter and receiver away from dust and dirt, and wipe
them with a damp cloth occasionally to keep both looking new.
SERVICE AND REPAIR
If your transmitter or receiver is not performing as it should, take it to your local RadioShack
store for assistance. To locate your nearest RadioShack, use the store locator feature on
RadioShack's website (www.radioshack.com), or call 1-800-The Shack (843-7422) and follow
the menu options. Modifying or tampering with the transmitter or receiver's internal components
can cause a malfunction and might invalidate its warranty and void your FCC authorization to
operate it.
! IMPORTANT !
FCC INFORMATION
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult your local RadioShack store or
an experienced radio/TV technician for
help.
• If you cannot eliminate the
interference, the FCC requires that you
stop using your audio link.
Changes or modifications not expressly
approved by RadioShack may cause
interference and void the user’s authority to
operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device may
not cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
Product:
Wireless 5.8 GHz
Digital Audio Link
Model:
15-1974
Responsible
Party:
RadioShack
100 Throckmorton
Fort Worth, TX
76102
Phone:
817-415-3200
BOTTOM VIEW