TOLLS REQUIRED
Hobby knife
Needle nose Pliers
Phillip screw driver
Awl
Scissors
Wire Cutters
(Purchase separately)
Hex Wrench
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
Sander
1.5mm
A B
!
CA
L/R
Assemble left and right
sides the same way.
X
Drill holes using the stated
size of drill
(in this case 1.5 mm Ø)
Use epoxy glue
Take particular care here
Hatched-in areas:
remove covering
film carefully
Not included.
These parts must be
purchased separately
Check during assembly that these
parts move freely, without binding
Apply cyano glue
The pre-covered film on ARF kit may wrinkle due to variations
of temperature. Smooth out as explained right.
* Use an iron or heat gun. Start as low setting. Increase the
setting if necessary. If it is too high, you may damage the
covering.
Low setting
SILICON
EPOXY A
EPOXY B
CA
GLUE
Epoxy Glue (30 minutes type)
( 5 minutes type)
Silicon Glue
Cyanoacrylate Glue
Minimum 4 channel radio
for airplane
9 x 6 for .25 - 2 cycle engine
9.5x6 for .32 - 2 cycle engine
Silicone tube
Extension for aileron
servo.
.25 ~ .32 - 2 cycle
REQUIRED FOR OPERATION (Purchase separately)
.Motor control x1 .Aileron x1
.Elevator x1 .Rudder x1
(Purchase separately)
Read through the manual before you begin, so you will have an overall idea of what to do.
CONVERSION TABLE
1.0mm = 3/64”
1.5mm = 1/16”
2.0mm = 5/64”
2.5mm = 3/32”
3.0mm = 1/8”
4.0mm = 5/32”
5.0mm = 13/64”
6.0mm = 15/64”
10mm = 13/32”
12mm = 15/32”
15mm = 19/32”
20mm = 51/64”
25mm = 1”
30mm = 1-3/16”
45mm = 1-51/64”
