Now take a look at the power supply bus board of the modular system and the
connection cable of the new module. The first wire is marked red in the supplied
flat ribbon cable. On the bus board in a Eurorack housing, the lowest two
contacts carry -12V. Please ensure that the first wire with the red marking is
always connected to the -12 7Volt side of the base. Unfortunately, the bus system
does not have any polarity protection.
Once you have connected the cable, you can place the module in the correct
position and install it using the enclosed screws and washers. Please use the
plastic washers - so you can largely exclude damage to the painting and
silkscreening.
If everything has worked out and you have checked the connections, you can
turn on the power. At the same time a few of the LEDs should light up. If this is
not the case, interrupt the current immediately and search for the error. In most
cases, however, the oscillator will now work and we can focus on the operation.
of
7
16