Radicom RW8300M Series, Руководство дизайнера

Страница: 57 / 62

`
RW8300 (USB) Designer’s Guide Draft v.037 (04-20-17) 57
the end product (including the transmitter) and obtaining a separate FCC & IC authorization.
Contains FCC ID: K7T-RW8300 Contains IC: 2377A-RW8300
Labeling Requirements
To maintain compliance, the end product hosting the RW8300 module must be properly
labeled to identify that this module is installed. This transmitter module is authorized
only when used in devices where the antenna is installed such that 20 cm is maintained
between the antenna and users. The final end product must have a label located in a
visible area with the following information:
The XXXXXXX reflects the correct model installed into the host equipment: The
models are RW8300-a, or RW8300-c.
The label shall be securely affixed to a permanently attached part of the device, in a
location where it is visible or easily accessible to the user, and shall not be readily
detachable. The label shall be sufficiently durable to remain fully legible and intact on the
device in all normal conditions of use throughout the device’s expected lifetime. These
requirements may be met either by a separate label or nameplate permanently attached to
the device or by permanently imprinting or impressing the label directly onto the device.
The label text shall be legible without the aid of magnification, but is not required to be
larger than 8-point font size.
End User Information:
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF Exposure compliance. The end user should NOT
be provided any instructions on how to remove or install the device. The user’s manual
for end users must include the following information in a prominent location.