9
Place the U shaped foam insert into the panel
cut out with open side up.
fig. H
Install the rubber sandwich gasket on the gray
mounting plate, making sure the gasket straddles
both sides of the mounting plate.
fig. I
Place the gray mounting plate with gaskets on
the pool interior side of the panel cut-out, with the
white plate on the exterior of the panel. Secure
the assembly with 2
¼
” countersink bolts and
T-nuts loosely through 4 pre drilled corner holes
in the gray mounting plate, the wall panel and the
white mounting plate.
fig. J
Use the fifth bolt and T-nut at the bottom center
hole in the mounting assembly and tighten firmly.
Do not over tighten.
fig. K
Slip skimmer body through the white plate to
the gasket on the gray plate.
fig. L
Secure tightly with 2 pan head screws (different
style screws in the skimmer hardware bag) from
the water side through the gaskets and gray plate
into the skimmer body center hole on each side.
fig. M
Tighten the 4 corner bolts, firm, do not over
tighten.The skimmer faceplate is attached after
the liner is installed.
For Skimmer Assembly instructions for
Inground installation,
see page 20.
SKIMMER ASSEMBLY
H.
I.
Mounting Plate
Gasket
J.
K.
L.
M.
U-shaped
Foam Insert
White
Mounting
Plate
Gray Mounting Plate
w/gasket installed
Skimmer
Skimmer Cut-Out
Pool Interior