12
•
COOLING
Press the COOL button (or the C button in figure 2 on the remote control) to activate the cooling mode: the re
-
spective icon lights up. The cooling system is activated.
•
SPEED CONTROL
Press the SPEED button (or the F and G buttons in figure 2 on the remote control) to adjust the air speed. The
speed can be set to a value chosen from low, medium or high. A luminous indication on the product indicates
the selected speed:
LOW MEDIUM HIGH
•
SWINGING
Press SWING (or the button B in figure 2 on the remote control) to activate the oscillation of the vertical flaps
inside the grille which allows to automatically direct the air flow in multiple directions.
•
TIMED OPERATION
Normally the product works continuously but it is possible to set it in order to work for a limited period and then
switch off automatically. Press the TIMER button (or the button E in figure 2 on the remote control) to set the
timing from 0.5h to 7.5h in 0.5h increments with each press. 5 seconds after selecting the time, the function will
activate automatically.
To deactivate the function, set an operating time of 0h (all numbers on the upper part of the display are off).
•
PROTECTION FOR LACK OF WATER
If the cooling function is activated but there is not enough water in the tank, the indicator light starts to flash and
5 "beeps" are emitted to draw the user's attention.
As soon as the water level in the tank is restored, the indicator light goes off and the product starts again.
r
efill
/
drain
the
water
tank
•
It is possible to add water to the tank either using a container (figure 3-A) or using a tube (figure 3-B). In both
cases:
-
Disconnect the product from the power supply;
-
Open the filler flap or connect the tube as shown in figure 3 (A and B);
-
Fill with drinking water checking the level thanks to the appropriate indicator.
Warning:
Do not spray water on the engine or other electrical parts;
Do not exceed the maximum level indicated;
Use only drinking water;
Do not leave the water hose permanently connected to the product.
•
To empty the tank it is necessary to unscrew the drain plug indicated in figure 3-C:
-
Disconnect the product from the power supply;
-
Open the drain plug located on the rear side;
-
Close the drain plug at the end of the operation.
w
iring
diagram
•
The wiring diagram of the product is shown in figure 4.
Содержание AER Pro N
