Radial Engineering Ltd.
X-AMP Reamper™
True to the Music
®
3
FEATURE SET: OUTPUT PANEL
8. LEVEL CONTROL: The output LEVEL control sets the volume level
going to the guitar amplifiers. This potentiometer is recessed to
prevent accidental change and is adjusted using a guitar pick or flat-
head screwdriver.
9. CLIP LED INDICATOR: To ensure the signal from the mixer or
recorder does not overload the X-Amp, a clip indicator on the front
panel provides clear viewing. If this LED illuminates, reduce the signal
level.
10. DIRECT OUT-1: This ¼” output connects to guitar amp-1. This is a
transformerless, direct-coupled output and is used to connect to your
primary guitar amplifier. This provides the primary ground path for the
X-Amp.
This output must always be connected to a properly grounded
amplifier
.
11. POLARITY 180º: The polarity reverse works with the transformer-
coupled OUT-2 ¼” output jack. This flips the polarity of the output to
allow two amplifiers to play ‘in-phase’.
12. ISOLATED OUT-2: This ¼” transformer isolated output connects to
your second amplifier. Transformer isolation allows use of two amps
without introducing hum and buzz caused by ground loops.
13. GROUND LIFT OUT-2 (located on side): This recessed switch gives
you the option to bypass the transformer isolation and convert the
OUT-2 into a direct and grounded output. It is factory set to LIFTED
(inward position) to provide a safe and noise free connection to
amplifiers. See page 9 for more information about using this feature.
7
8
10
11
12
13
9
