True to the Music
®
Radial Engineering Ltd.
P
HAZE
Q 500 Module
8
7
1
4
3
2
6
5
Rear Panel
1
FEATURE SET
1. BLEND – Controls the mix between the
original (dry) signal and the phase altered
(wet) signal.
2. PHASE SHIFT – Used to set the phase
relationship between the dry and wet
signals or between two devices when
using a stereo source.
3. INVERT - 180º polarity reverse shifts
the phase shift range from 0º to 180º to
181º to 360º for control over the complete
frequency cycle.
4. ON (phase shift) – Used to bypass the
phase shift section and compare the
original sound with the phase altered
signal.
5. FILTER – Sets the high frequency cut
off range of the low-pass fi
lter. This
lets you apply the phase effect to lower
frequencies.
6. SHIFT - Changes the fi lter range from the
high range (3kHz to 38kHz) to the low
range (300Hz to 3.8kHz)
7. ON (fi lter) – Used to bypass the fi lter
section and compare the processed
signal with the original.
8. OMNIPORT - Available when used with
the Radial Workhorse, the Omniport is
assigned as a direct dry signal output for
re-patching to other devices.
