Radcal Accu-Gold Touch, Руководство пользователя

Страница: 12 / 20

Accu-Gold Touch User Guide
12
Measurement Output Selection –
This table
shows on which
screen the
output will be
shown.
* Any of the outputs
can be shown on
screens C1 and C2.
Value Screen* Definition
Digitizer
Air Pressure
Duration
FWHM Duration
Pulse Count
Multi-Sensor
Dose MS1 Dose Integral
Dose / mAs mA Dose / mAs
Dose / Pulse Dose / Pulse
Dose Rate MS2 Dose Rate
Dose Rate Max Maximum dose rate encountered
Dose Ratio AGMS / IC Multi-sensor dose divided by ion-chamber dose
Filtration MS2 Measured beam-filtration thickness.
HVL MS1 Half value layer result.
kV MS1 kV average
kVp MS2 Average peak voltage
Ion Chamber
Dose IC Dose Integral
Dose / Pulse Dose / Pulse
Dose Rate IC Dose Rate
Dose Rate Max Maximum dose rate encountered
Temperature Temperature measured by ion chamber.
The atmospheric corrections compensate for the effects of variations in the current
temperature (T in C) and pressure (P in kPa) on an unsealed ion chamber and uses the
following equation: Displayed value = (101.3/P) * ((T + 273.15)/295.15) * Instrument value
Exposure duration from start to stop trigger. If pre-pulse detection was activated,
duration is the duration of the main signal without pre-pulse.
Full-Width at Half-Maximum duration. The width of the time interval within which
the signal is at least half the peak signal.
Measurement pulse count.
MS1
IC
DD
DAP
DAPChk
MS2
IC
DD
DAP
DAPChk