RACOM RipEX 1.12.0, Руководство пользователя, Страница: 124 / 189

Note: There is not the possibility to set Broadcast address, since
Cactus broadcast messages always have the address 0x00. Hence
when the Broadcast is On, packets with this destination are handled
as broadcasts.
Address translation
Table
Mask
Slave
Broadcast accept
• Max gap timeout [ms]
Default = 30
The longest time gap for which a frame can be interrupted and still received successfully as one
frame. It should not be set below 10ms, while 15–40 ms should be OK for a typical Cactus protocol
device.
Comli
Comli is a serial polling-type communication protocol used by Master-Slave application.
When RipEX radio network run in Router mode, more Comli Masters can be used within one Radio
network and one Slave can be polled by more Masters.
Broadcasts packets are not used, so the configuration is using only some parameters described
Common parameters .
Mode of Connected device
Master
Address translation
Table
Mask
Slave
DF1
Only the full duplex mode of DF1 is supported. Each frame in the Allen-Bradley DF1 protocol contains
the source and destination addresses in its header, so there is no difference between Master and Slave
in the Full duplex mode in terms of RipEX configuration.
• Block control mode
List box: BCC, CRC
Default = BCC
According to the DF1 specification, either BCC or CRC for Block control mode (data integrity) can
be used.
• Broadcast
According to the DF1 specification, packets for the destination address 0xFF are considered
broadcasts. Hence when Broadcast is On, packets with this destination are handled as broadcasts.
Address translation
Table
RipEX Radio modem & Router – © RACOM s.r.o. 124
Advanced Configuration