Programming Your Guard-It
TM
Autodialer
4 - 4
Guard-It
TM
Owner's Manual
2
PHONE
NUMBERS
Example:
To configure input channel 3 to alarm on Open Circuit, from the top menu
press:
1 3 1
Refer to Appendix A for additional information on programming for analog
signal inputs.
4.1.2
Phone Number Programming
You must program at least one phone number for your Guard-It
TM
autodialer
to dial when it has an alarm to report.
!
Note:
Until you do so, any alarms which are detected will be automatically
acknowledged without any alarm calls being placed.
To program phone numbers, you must first select which of 8 available phone
numbers (first, second, etc.) you want to program. The voice menu will ask you
for this number, which will be a number from 1 to 8. Then it will recite the
presently programmed phone number for that selection, if any. Then it will
allow you to accept the current entry by pressing pound (#), or else enter a new
phone number for that selection.
Be sure to include any necessary prefixes or area codes, just as you would dial it
on an ordinary telephone.
As you enter each digit, be sure to listen for the voice to repeat back that digit,
before you enter the next digit.
Example:
To program the third phone number to be 1 (510) 658-6713, from the top
menu you would press [2] for phone number programming, then [3] to select
the third phone number, then:
1 5 1 0 6 5 8 6 7 1 3 #
Listen carefully as the completed entry is repeated back to you, to be sure it
was entered and accepted correctly.
To delete a phone number, program it to be 00.
For example, to clear out the fourth phone number, from the top menu you
would press [2] for phone number programming, then [4] to select the fourth
phone number, then:
0 0 #.
