2
Tilt-GDC3
1. Test Button / LED Indicator
Test Button:
- Press the Test button to transmit a learning code to GDC-3.
- Press the Test button to report garage door position and enter test mode for 3 minutes. Under Test Mode, the LED
will light up whenever the Garage Tilt Sensor is activated.
LED Indicator:
- The LED will flash for 3 times when it is transmitting a learning code.
- The LED will light up whenever the device is triggered under Test Mode.
- The LED will light up whenever the tamper switch is activated.
- (Door opened) When experiencing device fault or under Test Mode, the LED will flash for 6 times.
- (Door closed) When experiencing device fault or under Test Mode, the LED will flash for 6 times. After 10 seconds,
the LED will flash for 3 times.
- When the battery is exhausted, the Garage Tilt Sensor will stop all function, the LED will flash every 4 seconds.
2. Mounting Holes
Used to fix and screw the Garage Tilt Sensor directly on the top of the garage door.
3. Tamper Switch
When the Garage Tilt Sensor is mounted, the Tamper Switch will be fully compressed against the wall. When the device
cover is opened or when it is removed from the mounted surface, the Tamper Switch will be activated. The LED will flash
for 6 times and send a tamper open signal to notify user(s) of this condition.
4. Battery Insulator
5. Battery Compartment
The Garage Tilt Sensor is powered by one CR123 3V Lithium battery. When the battery voltage is low, a low battery
signal will be sent to the Control Panel to notify user(s) of this condition.
Getting Started
Learn Tilt-GDC3 into GDC-3
Pull out the battery insulator of Tilt-GDC3 to power on the device, and connect GDC-3 to power supply.
Press the learn button of GDC-3 once to enter learning mode. The GDC-3 will emit one beep, and the red LED
will begin to flash.
Press the Test Button of the Garage Tilt Sensor to send a learning code, the LED will flash for 3 times.
If learning is successful, GDC-3 will emit 2 beeps to indicate. If the Garage Tilt Sensor has already been added
into the GDC-3, the GDC-3 will emit a Di-Do sound to alert the user.
Press the learn button of GDC-3 once again to return to normal mode, the red LED will turn off. Alternatively,
GDC-3 will exit learning mode automatically with 5 beeps after 1 minute of inactivity.
< NOTE >
The Garage Door Control supports only one tilt sensor. If learning in a second Tilt-GDC3 into GDC-3, the old
Tilt-GDC3 will be replaced by the newly learned Tilt-GDC3.
Adding GDC-3 into the System (Inclusion)
The device supports both classic inclusion process and SmartStart inclusion process.
