1. First use of machine
When you use the machine for the first time “new out of the box”, there are some items to think of.
First you should install some new parts in the machine and there are some subjects to think of when
using the machine:
•
First you find some fuses. You should install one fuse in the round fuseholder at the machine
panel. Install this after you are sure that no high power (110/220V) cable is connected to the
machine! First turn (left) the fuse holder from the machine panel, then put the fuse in the
holder and turn the holder inside the machine panel again.
•
The remote control (RC) works by 2x 1.5V batteries. These should first installed into the
RC. Open the battery space of the RC and put the batteries in the right way. Then close the
RC again.
•
When you want to use the machine with the external battery and you don't use the machine
at 220V with the power cable, you should assure that the external battery is fully charged. To
do this, you should connect the round charger cable to the round battery box and the other
connector to the 110/220V power connection. When the battery of the machine is still
charging, the led on the charger is red, it will turn into green when the battery is charged.
You also hear the cooling in the charger turning when it is still charging.
•
When the remote control is turned “ON” (pressing for about 3 seconds!!!), the batteries will
slowly be empty after some time, even when the RC isn't used during that period. When you
finished using the ball machine, turn off the RC by pressing the “Power button” for about 3
seconds!!!
•
When you use the ball machine with the external battery, you need to put the “Power
button” on the machine panel on “DC” and the battery box connected to the round machine
panel connector with the special cable. When using the machine on 220V, you need to
switch the machine on “AC” and the 220V cable connected to the flat connection of the
machine panel and connected to a 220V power connection (with cable reel?) at the
tenniscourt. After usage, turn off the machine by turning the Power switch to the middle.
•
The ball bucket could easily be put upside down on the machine by moving the handle
through the rectangle hole of the ball bucket.
•
When the Power has been set the right way and the power lamp is lighting, the Remote
Control (RC) could be turned on (press about 3 secs the power button on the RC), the RC
then show some values in blocks at the speed, frequency and some settings on the display of
the RC. Don't stand before the machine (the side where the balls will be shot out of the
machine) when the power has been turned on. When pressing the “>/||” button of the RC, the
shooting wheels will start turning and the machine automatically will start shooting after
about 3 seconds. Press again the “>/||” button to stop the machine.
•
The 2 front feet, at the bottom of the machine, will be responsible for the right angle of the
machine. Even though it is not right to change the feet many times and the factory set the
