background image

TOGGLER® brand SNAPTOGGLE® Toggle Bolt Installation Instructions 

DO NOT attempt to test the snaptoggle as you will be unable to use it.  Should 

you need additional snaptoggles, you may purchase them at Lowes or find a   

local resource on www.toggler.com 

 
IMPORTANT!
  If your house is older (maybe a Victorian?) with lath board plaster ceilings and walls, DO NOT use the 
new drywall anchor system.  Old lath board plaster walls are not strong enough to hold drywall anchors. You must at-
tach the pot rack to wood joists with 4” wood hook/screws (included with your pot rack).   

 

1)

  Using an electric drill with 

½”

  bit, drill a hole at each of your marked  

      points.  Hold metal channel flat alongside plastic straps 
      and slide channel through hole.  Minimum clearance behind ceiling 
      should be 1 

”. 

 

NOTE: If a wood joist happens to be located at one of those points, use one of 
the  
4” wood screw hooks provided and screw it into the joist.  (Pre-drill a hole in the 
joist so the hook is easier to screw into the hole.)  
 
We also understand--if you prefer, you can use the two wood screw hooks pro-
vided and drive them into the joists so you’re confident with the strength of the 
attachment.  However, to do so will likely require placing a cross bar (not includ-
ed) 

     above the ceiling which will often necessitate a carpenter’s services. 

 

2) 

Hold ends of straps between thumb and forefinger and pull toward you until 

channel rests flush behind drywall.  Slide plastic cap along straps with other 
hand until flange of cap is flush with the ceiling

 
                     

           3)

  Bend straps at ceiling by pushing side to side, snapping  

                   off straps level with flange of cap. 

 
 

 4)

  Insert screw hook and tighten until flush, then stop.   

 
NOTE: If you are also installing Trim Ceiling Covers (a 

RACK IT UP

 accessory), see pack-

age instructions before inserting and tightening bolt/hook. 
 

 

 

 

         

                                     Toggler ® Independent Lab Results

 

                                         (anchor load before failure per attachment point) 

 

                

TENSILE 

 

                    SHEAR 

 

 

      ½” drywall -  265 lbs. 

  

½” drywall - 241 lbs. 

 

 

       

 “ drywall - 356 lbs. 

            

” drywall - 324 lbs.                         

 
 

 

          Industry safety standards recommend ¼ of ultimate test load 

 
                  That’s’ it – You are now ready to hang your new pot rack! 

 

Ceiling 

Installation of Drywall Anchors 

U.S. Patent no. 6, 161,999 and foreign counterparts thereof and of 4, 650, 386.  Other patents pending.  TOGGLER and SNAPTOOGLE are worldwide registered trademarks of Mechanical plastics  Corp 

Отзывы: