Racing RAY400EPDW, Инструкция по эксплуатации

Страница: 8 / 9

8
6. TROUBLESHOOTING
Incidents Causes Remedies
Pump does not start - No mains supply
- Floater does not switch
- Check mains supply
- Bring floater in a higher
position
No flow - Inlet sieve is clogged
- Pressure hose in bent
- Clean inlet sieve water jet
- Reset hose
Pump does not switch off - Floater cannot sink down - Place pump properly on shaft
ground
Insufficient flow - Inlet sieve is clogged
- Reduced pumping capacity by
dirty and abrasive water
- Clean inlet sieve
- Clean pump and replace worn-
out parts
Pump switches off after short
operating period - Thermal cut-out stops pumps
due to dirty water
- Water too hot. Thermal-cut-out
stops pump
- Remove mains plug. Clean
pump and shaft
- Make sure that a water
temperature of max. 35°C is not
exceed