Racing RAC62PR-3, Оригинальное руководство пользователя

Страница: 30 / 40

30
6.3.2 Replacing wheels
1. Place the machine on a flat surface and put blocks
under a load-bearing part of the frame on the side of the
wheel to be changed;
2. using a screwdriver, remove the snap ring
(1)
and the
washer
(2)
;
3. pull out the wheel
Smear some waterproof
grease on the axle and after refitting the wheel; carefully refit the washer (2) and the
snap ring (1).
If you have to replace one or both rear wheels, make sure
that any differences in their external diameter does not exceed 8-10 mm; on the contrary,
to prevent an uneven cut it will be necessary to adjust the alignment of the cutting deck.
6.3.3 Replacing and repairing tires
All puncture repairs or replacements will have to be carried out by a tire repair expert in
accordance with the methods for the kind of tire used.
6.3.4 Replacing a fuse
The electric system and the electronic card are protected by a fuse. When it blows the
machine stops, so in this case:
1. remove the engine housing (1)
using a hand;
2. replace the fuse (2) with another
one with the same capacity;
3. remount the engine housing (1).
The fuse capacity is indicated on
the fuse.
2 1
1
2