ORIGINAL INSTRUCTIONS
14
5. OPERATION
a. Starting the operation
Cold starting
-
Switch on the tool by putting the Start/stop button on the position I (ON).
-
Push the primer bulb 5-7 times, until fuel comes into the primer bulb.
-
Pull the choke lever to the START position.
-
Pull the starter cord until the engine starts.
-
Pull the choke lever to the RUN position.
-
Allow engine to warm up for a few minutes before using.
-
Push the safety switch then the throttle trigger to start the operation
Warm starting
The warm starting can be done when the tool was switched off but still hot.
-
Switch on the tool by putting the Start/stop button on the position I (ON).
-
Push the primer bulb 5-7 times, until fuel comes into the primer bulb.
-
The choke lever must be kept in the RUN position. If it is not the case, restart the machine by performing a cold
starting.
-
Pull the starter cord until the engine starts.
-
Allow engine to warm up for a few minutes before using.
-
Push the safety switch then the throttle trigger to start the operation
