ORIGINAL INSTRUCTIONS>EN
6. BEFORE USE
6.1) Charging the appliance battery (see fig. a)
Note:
The battery is supplied partially charged. Before first use, charge the battery in the charger for at least 1
hour. This guarantees full battery power. Li-ion batteries can be charged at any time without adversely
affecting their service life. Interruption of the charging process will not damage the battery.
If the battery charge level indicator lights up red during use, the battery is at less than 30% of its
capacity and needs to be charged.
Never charge the cordless appliance when the ambient temperature is below 10°C or above 40°C. If a
lithium-ion battery is to be stored for an extended period, the charge level should be checked regularly.
The optimum charge level is between 50% and 80%. The storage climate should be cool and dry and
the ambient temperature should be between 0°C and 50°C.
6.2) Start charging:
♦ Connect the charger to a 100–240 V
∼
50/60 Hz power source.
♦ The battery is fully charged when the battery level display changes from red to green.
6.3) Stopping charging:
♦ Disconnect the charger from the mains power supply.
7. ASSEMBLE THE ATTACHMENTS
7.1) Usage:
With the torque attachment screwing stops as soon as the screw is tight. Set the required torque from
one of the 10 levels.
The eccentric attachment allows you to screw even in locations that are close to the wall.
The angle attachment allows you to screw at right angles.
The cutting attachment allows you to cut soft materials, such as card and similar materials up to a
thickness of 6 mm.
7.2) Assembly:
Note:
Before carrying out any work on the appliance, ensure that the rotation direction switch is in the middle.
This prevents unintentional switching on.
Start by removing the rubber cap from the tool holder (see fig. b).
Now you can fit the supplied attachments to the appliance in 45°steps. Fit the attachment onto the
appliance so that the attachment clicks into place. (See fig. C, example: torque attachment).
7.3) Dismantling:
To remove the attachments from the appliance, press the release button and pull the attachment
forwards.
Afterwards, replace the rubber cap on the tool holder.
9
