RACCEWAY MONA, Руководство пользователя

Страница: 51 / 53

32
1,Charge:the charger must be the assorted one . First, connect the power to the charger. Second, insert the
charger
’ s out-put connector to the battery ’ s in-put connector. Third, when the signal light is on, please pull out
the battery ’ s in-put connector first. The common single charging time is about 6-8 hours. if the battery be blow-
up, the charging or discharging must be stopped.
2, Avoid over discharge: charge the battery timely after discharging, in order to avoid the over-discharge.
Secondly: Requirements on storage
1.li-battery cannot be stored at the palace where is over hot and over humidity. therefore the temperature of
the storage should between -20 to 55degree,and further more the storage must be kept in dry, clean and the
battery should not be piled up.
2. the battery cannot be stored for a longtime without charging. The battery should be charged once a month.
The battery should be stored with fully charged.
Thirdly: Maintenance
1, When you test the voltage of the single piece of the battery-cell, you have to test the cell directly, not by
the wire. By doing that, it can avoid the voltage decline.
2,You have to wear the glove or clip the finger nails before you take out the single piece of the battery. So as
to avoid damage the cover of the battery.
3, Forbid bending the battery cell, the top edge of the seal-up. And also the falling ,hitting and short circuit
are prohibited .
4, When you re-assemble the battery, there are some special notes we have to concerned in mind. The
temperature of the electric iron should below 350℃; the welding time must be less than 3 seconds; and the
frequency of welding should be no more than 5 times; the second welding must be done after cooling.
Cleaning:
a) Never use high water pressure to wash the scooter. Soaked electrical parts and wiring will affect the performance.
b) Never apply lubricant to the drum brake and the tire.
c) Use lubricant to clean the metal parts of the scooter.