RACCEWAY KOBRA, Руководство пользователя

Страница: 18 / 105

-
17
-
•
Use only the charger designed for this electric scooter (never use a charger from another
model). Before charging, set the switch to the OFF position and remove the key. Use the
charger in a dry and well-ventilated area.
•
The charger is for indoor use only. Protect the charger from water to avoid short circuiting.
Do not use in wet, flammable, or explosive environments. Do not remove the plug by pulling
the cord, always grasp the charging port by the metal body.
•
First, plug the charger's output plug securely into the battery receptacle, and then insert
the input plug into a power outlet. The charger indicator lights up to indicate that charging is in
progress.
•
When the light changes from red to green, it indicates that the battery is fully charged.
Typically, it will take approximately 6-10 hours for the battery to fully charge. lf you have time,
it is recommended to charge it for 2 more hours after the indicator light turns green. (This will
positively affect battery life).
•
When the green light is on, the charger is in a maintenance charging state. lf you are away
for a long time, you should remove the charger plug, especially in hot weather.
•
The charger heats up during charging, so keep it away from heat. Always keep the charger
dry and clean. The electronics inside are under high voltage, so never disassemble it yourself.
•
After charging, first unplug the power plug and then remove the output connector from the
battery. Do not leave the charger plugged into a battery or wall outlet for an extended period of
time as this may damage the charger and cause a fire.
•
Keep the charger out of the reach of children while charging. Do not place anything on the
charger or allow any liquid to come into contact with the charger.
•
The first 10-15 charges are unstable, the charging time can be up to 12 hours, and the
charge indicator on the scooter display can show a partially discharged battery. After
formatting the battery, everything will be fine
•
Furthermore, the battery is protected by its own fuse 30A, which is stored from the side of
the plastic battery pack and secured with a plastic screw cap.
Charger has three charging options:
1. Remove the battery from the under-seat part, bring it to the electrical outlet and start
charging
2. Disconnect the battery in the under-seat part from the power connector, connect the
charger and charge
3.
The e-scooter has, above the rear wheel in the fixed part of the mudguard, a connector
for connecting the charger.
The charger has 2 diodes. The first (red) lights up when the charger is plugged in, while the
second signals charging. When the charger is connected, the first red light comes on
immediately and the second one lights up green, then red when everything is OK. lt will glow
green again when fully charged.