Racal Instruments 1260-93, Руководство пользователя

Страница: 24 / 96

User Manual 1260-93
Module Specific Syntax 3-2
OPEN 5.00; 5.19; 5.12
OR
CLOSE 5.00, 19, 12
OPEN 5.00, 19, 12
The module address does not have to be specified each time if
all channels are on the same module.
PSETUP Command
The PSETUP command causes the specified module setup to
be transmitted to the VXI Controller. The syntax used is:
PSETUP <module address>[;<module address>][;<module address>]…….
where <module address> is the address.
The responses to the PSETUP command for the 1260-93A/B
multiplexer is as follows:
1260-93A:
<module address>.1260-93A, 8 (1x4) 93 OHM 100 MHz MULTIPLEXER MODULE
<module address>.BBM
<module address>.END
1260-93B:
<module address>. 1260-93B, 16( 1X4) 93 OHM 100 MHz MULTIPLEXER MODULE
<module address>.BBM
<module address>.END
The response to the PSETUP command consists of a header
on the first line. The header describes the model number. The
next line designates the setup mode for scanning which, by
default, is Break-Before-Make (BBM). The last line containing
the "END" characters denotes no more information to report.
PDATAOUT
Command
The PDATAOUT command causes the specified module to
transmit the state of the CLOSED relays on the switching
module. The syntax used is:
PDATAOUT <module address>[.<module address>] [;<module address>]…..
The responses to the PDATAOUT command is as follows:
1260-93A:
<module address>.1260-93A 8 (1x4) 93 OHM 100 MHz MULTIPLEXER MODULE
<module address>.<channel>[,<channel>] [,<channel>]…….