Cautions
• All wiring MUST comply with local
electrical codes and should be installed
by a qualified electrician.
• Read entire Installation Manual before
proceeding.
TURN OFF POWER BY REMOVING
POWER FUSE OR TURNING
OFF CIRCUIT BREAKER
BEFORE INSTALLATION.
• Total lighting load must not exceed:
500 watts incandescent or 250 watts
fluorescent at 120 volts.
• Line Carrier Remote Control Systems
such as X-10, Leviton or Radio Shack are
incompatible with sensors and cause false
activations.
• Do not install on circuits feeding motor
loads such as kitchen appliances, HVAC
equipment, washer/ dryer or garage door
openers.
• Sensor functions best when movement
is across its detection pattern, not towards
the sensor.
Assembly and Wiring
1. Smart Task retrofit sensor installs on your
existing task lighting fixture.
2. The opening in your existing fixture switch
knockout MUST measure 1.08” x .525” in
order for retrofit sensor to fit properly as
shown below.
3. Bring power leads out of fixture .
4. Strip 1/2” of insulation from all leads.
Connect as shown in Wiring Diagram.
5. Twist on wire nuts. Secure with electrical tape.
6. Turn on power.
7. Adjust coverage angles of the sensor from
left to right only. Tighten tilt set screw.
Wiring Diagram
How are the Time, Sensitivity and
Photocell adjusted?
• Time Control: Sets the time that lights will
remain on after the Detection Zone is vacated
from approximately 5 seconds to 15 minutes.
Use small adjustment tool supplied to turn
clockwise to increase the time.
• Factory Setting: 5-8 minutes.
• Sensitivity: Increases or decreases the
responsiveness and range of the sensor.
Control Panel:
Turn controls gently. Do not force
past stops.
How Does Smart Task Work?
Sensitivity
Time Control
Photocell
The Smart Task
infrared sensor “sees”
small temperature changes caused by the
motion of people or pets within its Detection
Zone and turns on lights automatically.
How long do the lights stay on?
Lights remain on as long as there is move-
ment within the Detection Zone. Once the
zone is vacated, lights can be adjusted to
remain on approximately 5 seconds up to
15 minutes.
Will the sensor detect animals?
Smart Task may detect large animals.You can
limit animal detection by placing opaque tape
on the lower part of the lens or using the
bottom mask on the Lens Mask Kit provided.
What does Manual Override do?
Keep lights on by flipping the wall switch
two times within 5 seconds. Sensor resets
to auto mode at dawn. No extra wiring
needed.