RAB ProRak 26, Быстрый старт

Страница: 3 / 7

ProRak
MULTIBOARD
CONSOLE
STEP 1 of
6
Tools required:
4MM Allen Wrench
1. The pedestal pieces are A1, A2, A3 and A4 as shown in the picture.
2. Attach A2 to A1 with bumper molding facing upwards.
Note: The bottom of A1 will have a recessed hole where the confi rmat
screw will rest.
3. Attach A3 to A2.
4. Attach A4 to A2.
STEP 2 of
6
Tools required:
4MM Allen Wrench
+ Phillips Head Screwdriver
1. The pieces are B1 , B2 , 10U rack rails(4) , 4U rack rails(4) , 3/4"
black screws , keyboard tray slides , and the comp leted pedestals
from Step 1.
2. Attach the 10U rack rail s and 4U rack rails t o the predrilled holes
on B 1 and B2 with 3/4" black screws . Place B2 aside until step 5.
3. Remove the mounting slides & a ttach the two tray slides to the
predrilled holes on B1 with 3/4" black screws . The front of the
slides need a one inch gap between the slide and bumper molding.
4.
Attach B1 to A3 and A4
.
5. Make sure the t ray slides fac e each other.
6. The finished pieces will not stand on their own. Either lean against a
wall or lay on the ground for now.
A4 A3
A1
A2 A2
A4 A3
A1
A2 A2
A4
A3
A1
A2 A2
A4
A3
A1
A2 A2
B1
B1
Rack Screws
Confirmat Screws Rubber Pads
Rack Screws
Rubber Pads
NOTE: Only hand tighten the Confi rmat screws.
You will do a fi nal tightening in the last step.
Plac e rack rails over these holes on B1
and B2 with a two hole gap
Place keyboard slides over these
holes with a one inch gap between
the slide and bumper molding
B1
B2
B2
.
.
.
.