AL
TM
AREA LIGHT INSTALLATION INSTRUCTIONS
®
Page 2
MOUNTING (1) AL fIXTURE
DIRECTLy TO POLE
Fixed Arm mounting directly to 4” or larger square steel
pole. Note
Arm Orientation
detail on first page.
Loosen (4) door screws, open fixture. Remove
ballast cover.
Insert
Threaded Rods
into the pole and thread into
the
Bolster Plate
.
Feed wires from fixture through
Gasket
,
Arm
and
2nd
Gasket
and into pole. Make connections and
knot wires as a strain relief. Replace pole cap.
Line up extrusion slots with the
Threaded Rods
and
slide
Arm
and fixture on
Threaded Rods
.
Place flat washer, lock washer and nut on the
Threaded Rods
inside the fixture and tighten
securely.
1.
2.
3.
4.
5.
Bolster
Plate
Gaskets (2)
Arm
Threaded
Rods
MOUNTING (2) AL fIXTURES
AT 90° DIRECTLy TO POLE
Fixed Arm direct pole mounting of 2 fixtures at 90 de-
grees as shown below.
See steps 1-5 in “
MOUNTING () AL FIXTURE
DIRECTLY TO POLE
” section. Follow for each fixture
MOUNTING (2) AL fIXTURES
AT 180° DIRECTLy TO POLE
Fixed Arm direct pole mounting of 2 fixtures at 180 de-
grees as shown below.
See steps 1-5 in “
MOUNTING () AL FIXTURE
DIRECTLY TO POLE
” section. Follow for each fixture
MOUNTING (3) AL fIXTURES
DIRECTLy TO POLE
Fixed Arm direct pole mounting of 3 fixtures.
See steps 1-5 in “
MOUNTING () AL FIXTURE
DIRECTLY TO POLE
” section. Follow for each fixture
MOUNTING (4) AL fIXTURES
DIRECTLy TO POLE
Fixed Arm direct pole mounting of 4 fixtures.
See steps 1-5 in “
MOUNTING () AL FIXTURE
DIRECTLY TO POLE
” section. Follow for each fixture
