WPLED104 INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
WPLED104
Standard (15 Deg)
WPLEDC104
Cutoff (7.5 Deg)
WPLEDFC104
Full Cutoff (0 Deg)
4.97
[126,3]
4.58
[116,2]
4.97
[126,3]
1.30
[33]
4.58
[116,2]
MOUNTING TO WALL
1.
Orient
Wall Mounting Box
such that ‘TOP’ is pointing
up.
2.
Feed supply wires through
Gasket
and
Wall Mounting
Box
.
3.
Secure
Wall Mounting Box
to a sturdy wall. Use
appropriate mounting hardware such as lag bolts and
anchors with washers suitable for the mounting surface.
A
Leveling Bubble
is provided to level fixture.
4.
Check that
Gasket
is fully sealed.
5.
Slide the stainless steel
Tether
from the fixture into the
Key Hole Slot
of the
Clip
for hands free wiring.
6.
Wire the fixture using suitable wire connectors.
7.
Place wired fixture over the
Wall Mounting Box
and
tighten the
Top Screws
. Now tighten the
Lower
Screws
.
8.
Tighten
Close Up Plugs
and apply weatherproof
silicone sealant to all unused conduit entry points. Also
use sealant between the wall and
Wall Mounting Box
.
Wall Mounting
Box
Top Screws
Lower Screws
Close Up
Plugs (4)
Gasket
Tether
Key Hole Slot
Gasket
Leveling
Bubble
Leveling
Bubble
Clip
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1. Clean glass lens & fixture with non-abrasive glass
cleaning solution.
2. Do not open fixture to clean the LED. Do not touch the
LED.
