![background image](http://html2.mh-extra.com/html/rab-lighting/slim-37/slim-37_installation-instructions-manual_3120168002.webp)
SLIM 37 INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
TM
SLIM35 POLYSHIELD
RAB LIGHTING
3/22/2013
SLIM35 WIRE GAURD
RAB LIGHTING
3/22/2013
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation operation
or maintenance.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough to
touch. Do not clean or maintain while fixture is energized.
1. Clean glass lens & fixture with non-abrasive glass cleaning
solution.
2. Do not open fixture to clean the LED. Do not touch the LED.
TROUBLESHOOTING
1. Check that the line voltage at fixture is correct. Refer to
wiring directions.
2. Is the fixture grounded properly?
GUARD/ SHIELD INSTALLATION
1. Remove left and right
Cover Plates
as in figure 1 and
discard.
2. Mount wire guard and/ or poly shield with (4) #8-32 x 1/2”
Stainless Steel Screws.
Screws are provided with the
accessory.
Stainless Steel Screws (4)
FULL CUTOFF/ GUARD/ SHIELD
INSTALLATION
1. Remove (4)
Stainless Steel Screws
from the
Full Cutoff
Hood.
2. Mount wire guard and/ or poly shield over the full cutoff
hood with (4) #8-32 x 1/2”
Stainless Steel Screws
as shown
in figure 2. Screws are provided with the accessory.
Stainless Steel
Screws
Figure 1
Stainless Steel
Screws
Figure 2
Cover Plate
Full Cutoff Hood
Note: Guard and shield may be used together.
Note: Guard, shield and full cutoff hood may be used together
with (4) #8-32 x 3/4” stainless steel screws (supplied by others).
Stainless Steel Screws (4)
GUARD/ SHIELD INSTALLATION
Wire Guard and Poly Shield mounts with (4) #8-32 x 1/2”
Stainless Steel Screws
. Screws are provided with the
accessory. See figure 2 for Guard. See figure 3 for Shield
1. Remove left and right
Cover Plates
as in figure 1.
2. Line up guard and/ or shield with existing pre-drilled holes
in frame as shown, tighten screws.