LOTBLASTER 65W 110W 160W INSTALLATION
INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
™
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. This product must be installed in accordance with the applicable installation code by a person familiar with the
construction and operation of the product and the hazards involved.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
CAUTION: The fixture weighs 22lbs. Make sure pole and hardware supplied by others (if any) can withstand the weight of
the fixture.
LOTBLASTER WITHOUT
UNIVERSAL POLE ADAPTER
LOTBLASTER WITH
UNIVERSAL POLE ADAPTER
MOUNTING FIXTURE DIRECTLY TO
POLE
Follow steps below to mount the
Housing
to RAB square
pole and check that pole is drilled according to Pole
Drawing Detail -
1.
Loosen
Cover Screw (2)
to open the
Housing
.
2.
Feed supply wires from center opening of
Pole (not
supplied)
into
Housing.
3.
Line up
Bolster Plate
,
Pole
, and
Housing
. Insert
2-1/2”
Bolts (2)
and thread into
Bolster Plate
along with
washers and lockwashers (supplied) as shown below. Be
sure the gasket is between
Housing
and
Pole.
4.
Make necessary connections inside the
Housing
and
knot wires for strain relief.
5.
Close
Housing
cover and tighten the
Cover Screws (2)
.
6.
Secure
Pole Cap (not supplied).
Bolster
Plate
2.5” Bolt
(2)
Cover Screw
(2)
Pole Cap (not supplied)
Housing
Pole
(not supplied)
POLE DRILLING DETAIL
For non-RAB poles use these dimensions to drill the pole.
This template is not to scale. Please use measurements
shown. For pole pattern other than 2” On Center, use
accessory CAT# LOT-UPA (Universal Pole Adapter).