Installation Step by Step
1.
Remove the existing switch, if
necessary.
2.
Connect as shown in the wiring
diagrams. See page 3.
3.
Twist on wire nuts. Secure with
electrical tape. Mount LOS800 in
wall box with two screws provided.
4.
Place switch in OFF position
before turning on power.
5.
Press the Auto/Off switch IN to
“Auto”. After a short delay, the
lights will turn ON. When the room
is vacated, the lights will turn OFF
after the time delay you set.
6.
See “Adjustments” section for
control options. Only make adjust-
ments after a 3 minute warmup
period.
7.
Attach the wall plate.
Installation
2
WALL MOUNTING BOX
ADJUSTMENT
ACCESS COVER
(Removable only
when switch plate
is off)
Black
Red
White
Black
Caution:
• TURN OFF ALL POWER BY
REMOVING THE POWER FUSES
OR TURNING OFF THE CIRCUIT
BREAKER FOR YOUR SAFETY
AND TO PREVENT DAMAGE TO
THE UNIT.
• Please read this entire Owner’s
Manual before installing.
• All wiring should comply with
local electrical codes and requires
a qualified electrician.
• Make sure the total lighting load
connected to the LOS800 does not
exceed the following:
120v: 800w Incandescent &
Fluorescent
277v: 1200w Incandescent &
Fluorescent
Exceeding the wattage limits may
damage the unit. To switch more
wattage, an electrician can install a
relay to handle the load.
• Do not use LOS800 to control
high intensity discharge lights,
fans, heaters or motors. Small
bathroom exhaust fans may be
used with LOS800.
• The LOS800 may be used with
both standard and electronic
fluorescent ballasts.
Basic Wiring Diagram
Single Level Lighting
Multiple Level Lighting
Wiring Diagram
Caution:
• TURN OFF ALL POWER BY
REMOVING THE POWER FUSES
OR TURNING OFF THE CIRCUIT
BREAKER FOR YOUR SAFETY
AND TO PREVENT DAMAGE TO
THE UNIT.
• The supply ground wire must be
tightly secured to ground.
3-way Switch wiring Diagram
Wiring Diagrams
3
COMMON (WHITE)
HOT (BLACK)
LOAD
RED
RED
BLACK
BLACK
RED
RED
BLACK
BLACK/HOT
WHITE/COMMON
COMMON (WHITE)
HOT (BLACK)
LOAD
LOAD
LOAD
LOAD
4
5