![background image](http://html1.mh-extra.com/html/r-v-r-elettronica/tj5kps/tj5kps_user-manual_3112597016.webp)
TJ5KPS - Test Jig
12 / 14
User Manual
Rev. 1.0 - 18/02/04
At the end of the parameteres reading, click on OK to close the dialogue window:
•
Do click on
Slaves -> Slaves
At this point are available all the parameters as like are measured from RF
module
8. Procedure of module setting
Inhibit the power in entry to the module, switching off the exciter.
Click on SLAVES of the instruments bar, click on Slaves and select RF1, in order
to bring back the measurements and effect the setting of the module.
Measure on the PSSW 5040 board (Power Supply) the voltage on TP3, moving
the trimmer R58 up to obtain 60 mV.
Verify the presence of the 3,3 Volt on TP1 of the CPU card. Calibrate, if necessary,
working on TR12.
Measurement of the voltage on the 18 di JP3 and bring back it on the computer
working on TR4.