4 / 34
User Manual
Rev. 1.1 - 07/02/14
TELINK-SNMP2
5. Installation and confi guration procedure
This section provides a step-by-step description of equipment installation and
confi guration procedure. Follow these procedures closely upon fi rst power-on
and each time any change is made to general confi guration, such as when a new
transmission station is added or the equipment is replaced.
Once the desired confi guration has been set up, no more settings are required
for normal operation; at each power-up (even after an accidental shutdown),
the equipment defaults to the parameters set during the initial confi guration
procedure.
The topics covered in this section are discussed at greater length in the next
sections, with detailed descriptions of all hardware and fi rmware features and
capabilities. Please see the relevant sections for additional details.
IMPORTANT: when confi guring and testing the transmitter in which this telemetry
unit is integrated, be sure to have the Final Test Table supplied with the equipment
ready at hand throughout the whole procedure; the Final Test Table lists all
operating parameters as set and tested at the factory.
Note : all cases shown below are referred to TELINK-SNMP2 connects to a TEX-
LCD made by RVR.
5.1
Preparation
5.1.1 Preliminary
checks
Unpack the exciter and immediately inspect it for transport damage. Ensure that
all connectors are in perfect condition.
Provide for the following (applicable to operating tests and putting into service):
√
Mains power supply, 230 VAC (-15% / +10%), with adequate earth
connection.
√
Connection cable kit request (not included):
• Telemetry signal cable;
• Ethernet cable (cable with RJ45 connector) for connection to ADSL router or
LAN network.
