5 / 22
User Manual
Rev. 1.0 - 28/09/07
TCP/IP-INT-TEX
Note :
If you intend to connect it directly to a PC, it is necessary to use a
crossover ethernet cable. This is a basic prerequisite to ensure equipment correct
operation.
3) Connect the network cable to the relevant
POWER
connector on TCP/IP
interface.
5.2 First Power-On and Set-Up
Perform this procedure upon first power-up and each time you make changes to
the configuration this component is integrated into.
5.2.1 Web User Interface (WUI)
Once all connections previously described are performed, the equipment is ready
for commissioning.
The
WUI
(Web User Interface) allows you to adjust, modify or display the
configuration variables and operation data. Follow the procedure below to open
the
WUI
.
1) Open your web browser on your PC, and connect to
http://192.168.0.244
to
connect to the
WUI
(if LAN IP address was previously modified, it is necessary
to use the new one). The following page opens:
User Name
Password
Login
Menu 1
Note :
If address
http://192.168.0.244
does not work, check and set IP address as
192.168.0.XXX
(where XXX is a figure between 0 and 255, excluding 244 that is
TCP/IP interface default address). To change the IP address, follow the instructions
in the manual or in the online guide and technical help, specific for the Operating
System you use.