HC08CH-FM
1
/ 24
User Manual
Rev. 1.0 - 29/01/21
ELETTRONICA
1. Preliminary Instructions
• General Notices
The equipment in question is to be considered for
use, installation and maintenance by “trained” or
“qualified” personnel aware of the risks associated with
working on electrical and electronic circuits.
The definition of “trained” means personnel with the
technical knowledge required to use the device in
a manner that ensures their own safety and that of
other unqualified personnel under their direct
supervision when working on the equipment.
The definition of “qualified” means personnel with the training
and experience required to use the device in a manner
that ensures their own safety and that of other unqualified
personnel under their direct supervision when working on
the equipment.
CAUTION: The device may be equipped with an
ON/OFF switch which may not completely remove
voltage inside the device. It is necessary to disconnect
the power cord, or turn off the power panel, before
carrying out technical work, making sure that
the safety earth connection is connected.
Technical work that involves inspection of the device
with live circuits must be carried out by trained and
qualified personnel in the presence of a second trained
person who is ready to intervene by disconnecting the
power supply in case of need.
R.V.R. Elettronica
assumes no responsibility for injury or
damage caused by improper or incorrect use by personnel,
whether trained and qualified or not.
CAUTION: The device is not resistant to the ingress
of water and infiltration could seriously compromise its
correct performance. To prevent fire or electric shock,
do not expose this equipment to rain, infiltration or
moisture.
Please observe local regulations and fire regulations when
installing and using this equipment.
CAUTION: The device in question has internal parts
that pose the risk of electric shock: always disconnect
the power supply before removing the covers or any
other part of the equipment.
Ventilation slots and holes are provided to ensure reliable
operation of the product and to protect it from overheating.
These slots must not be obstructed or covered. The slots
must not be obstructed under any circumstances.
The product should not be incorporated into a rack unless
it is provided with adequate ventilation or the manufacturer's
instructions have been followed.
CAUTION: This equipment can radiate radio
frequency energy, and if not installed in accordance
with the instructions in the manual and the regulations
in force it can interfere with radio communications.
CAUTION: This equipment has an earth connection
on both the power cord and the chassis. Make sure they
are connected correctly.
Operating this appliance in a residential environment can
cause radio disturbances; in this case, the user may be
required to take appropriate measures.
The specifications and information given in this manual are
provided for informational purposes only, and may therefore
be subject to change at any time without notice and should
not be seen as binding to
R.V.R. Elettronica
.
R.V.R. Elettronica
assumes no responsibility or liability for
any errors or inaccuracies that may appear in this manual,
including the products and software described in it; and
reserves the right to make changes to the design and/or
technical specifications of the equipment, as well as to this
manual, without prior notice.
• Notice regarding the intended use and limitations on
use of the product.
This product is a radio transmitter suitable
for frequency modulated audio broadcasting
service. It uses operating frequencies that are
not harmonized in the designated user states.
The user of this product must obtain specific authorization
for use of the radio spectrum from the spectrum
management authority of the designated user state,
before putting this equipment into operation.
The operating frequency, the power of the transmitter, as
well as other characteristics of the transmission system, are
subject to limitations and are set out in the authorization
obtained.
2. Warranty
R.V.R. Electronica
guarantees the absence of
manufacturing defects and the proper functioning of the
products, within the terms and conditions provided.
Please read the terms carefully, because purchasing
the product or accepting the order confirmation
constitutes acceptance of the terms and conditions.
For the latest updates on the legal terms and conditions, please
visit our website (WWW.RVR.IT) which can also be modified,
removed or updated for any reason without notice.
The warranty will be void in the event of opening the
equipment, physical damage, misuse, modification,
repair by unauthorized persons, carelessness and
use for purposes other than those intended.
In the event of a defect, proceed as described below:
1 Contact the retailer or distributor from whom the
equipment was purchased; describe the issue or
malfunction to verify if there is a simple solution.
Retailers and Distributors are able to provide all information
relating to the most common issues; they can usually repair
the equipment much faster than the manufacturer could.
Installation errors can normally be identified directly by
retailers.
2 if your retailer cannot help you, contact
R.V.R. Elettronica
and describe the issue; if the staff deems it necessary,
the authorization to send the equipment will be sent to
you with the appropriate instructions;
3 Once you have received authorization, you can return
the unit. Pack it carefully for shipping, preferably using
the original packaging and duly sealing the package.
IMPORTANT
The lightning bolt symbol inside a triangle on the product draws attention to operations for which
care must be taken to avoid the danger of electric shock.
The exclamation point symbol inside a triangle on the product informs the user of the presence
of instructions in the manual accompanying the equipment, which are important for operation
and maintenance (repairs).
