R.V.R. Elettronica 4CX7500, Техническое руководство

Страница: 30 / 82

Date: 25/07/03 R.V.R. Elettronica S.r.l. (BO) VJ10000-TE - R.F. Tube Amplifier
30
CHAPTER 3
EQUIPMENT INSTALLATION
3.1 INTRODUCTION
This chapter contains the necessary information for the installation and the preliminary
checks of the VJ10000-TE amplifier.
3.2 UNPACKING
Remove the equipment from its packing, Verify that the unit that isn’t damaged during the
transport. Controls all parts on the front panel are operative.
First: remove the transformer from the packing.
Second: remove the lateral ant frontal pannel.
The necessary equipment are: a screwdriver with cross head , a soket wrench 7 mm and 10
mm, a setscrew wrench M6, M8.
Make sure to have a container where put all the screws. Remount all screws and to make
sure that isn’t component outside the appropriate position.
Then insert the power transformer support into rack, to make sure to have removed the
screws with the setscrew wernch M6. Now remove the plexiglass protection and connect the
appropriate contacts, use for this operation setscrew wrench M8, and a setscrew pipe M6.
After, insert the cart of the transformer interior shot the back rack, make sure to have
removed first the four screws M6 with the key to setscrew wrench M6.
MAIN PANNEL
LATERALE PANNEL REAR PANNEL