R-Quest TCP-7200, Руководство пользователя

Страница: 11 / 38

11
Once the parameters (above) are set, the final step to configuring the system
for printing is to ensure that the printer is in position and the system is able to
load discs.
To do this:

First place a disc into the input hopper.

Go to the Utilities | Loader Utilities | Load – the loader should pick the
disc.

Enter the Utilities | Loader Utilities | Loader Utilities | Extended Diags
section

Select Set Printer from the list

Open printer tray

Looking from above, use the left and right arrow keys to position the
disc centrally above the tray.

Once position is correct, press the ENTER key to save changes (to
cancel without saving changes, press the STOP key).

Close the printer tray, and remove the disc from the pick arm.
The system will now be ready for use.
Quick Start Copying
This quick start section assumes the Duplication Options
(Setup Menu | Job
Options)
are set as for use with the FlashJet 4800 printer (described earlier). If
they are not or if these instructions do not work then go to the Operation
chapter of this manual for detailed operating instructions.
Place one blank disc into the input, which is the front hopper (not the
individual pin) immediately in front of the left hand side stack of drives.
Use the up /\ or down \/ arrow keys to put the > cursor (on the Left of the LCD
display) next to the
Start Copying
menu line. Press the
ENTER
key to select that
menu function. If there is already an image on the hard drive the following
prompt will be displayed:
Read New Master?
Press the YES key. The next prompt will be for an Image name (this will be
the first prompt if there are no images on the hard disk).
Enter Image Name
[
]