R.P.S. Corporation KODIAK K10 STANDARD Disk Pad Assist, Руководство по эксплуатации

Страница: 12 / 29

- 12 -
K10-STANDARD-OP-EN
INSTALLING EDGE PADS:
1. Turn on machine power.
2. Raise the Scrubdeck by depressing the Brush switch
to the UP and OFF position and turn machine power
back OFF .
3. Select the correct Pads that best meet your cleaning
application. Consult your local dealer for assistance.
4. Remove any Pad previously attached to the EDGE/
ORBITZ Grip Face by pulling down from the corners
(SEE BELOW)
.
5. Once Grip Face is clear of any Pads, place pad want-
ed for application centered on the Grip Face (This will
leave a
½
'' overhang on all sides) .
6. Press upwards on the Pad to secure it in place (SEE
BELOW) .
7. With Pad attached securely to Grip Face of EDGE/
ORBITZ Deck, the machine is ready to use.
LEVELING EDGE DECKS:
NOTICE
All Scrubdeck’s should be level at time of machine
delivery. If machine Scrubdeck is not level - Contact your
Servicing Dealer.
1. Drive machine to a flat level surface and raise the
Machine Deck by depressing on the Scrubdeck Switch
on the control panel.
2. Turn Machine OFF .
NOTE: Deck should be equipped with a Red Buff Pad
or a Blue Cleaner Pad if not already.
3. With the correct Pad attached to the machine, press
the Scrubdeck Switch and lower the machine deck just
until it touches the floor, then turn off the machine.
4. Using Deck Levels
(A)
located on the sides of the
Deck, make sure that the Deck is level. If not, loosen
the Adjustable Arms attached to the EDGE/ORBITZ
deck by loosen the locking Nuts
(B)
and turning the
hexagonal arm
(C)
on each side of the Scrubdeck to
level it
(SEE BELOW)
.
5. Extending the adjustable arms raise the front and low-
er the rear of the Scrubdeck.
6. Once Scrubdeck is level - retighten and raise Scrub-
deck.
B
B
C
B
B
C
A A
NOTICE
NEVER place aggressive Pads (Maroon Prep, Dominator
HD Strip, etc.) directly onto the Grip Face. Always use
Red or Blue Spacer pad to prevent Grip Face damage.