Page 3
VIN1 FS: 3716
VIN2 FS: 3715
VIN3 FS: 4094
VIN4 FS: 4095
FORMAT: RMY POLLED
POLL ADDR: a
OUTPUT RATE: 15 HZ
BAUD: 9600
OFFSET X,Y,RATIO: -251, 75, 847
COMPASS DAMPING: SLOW
WATCHDOG TIMER: ENABLED
1.2.6 POLLED MEASUREMENTS
When the serial output format is RMY POLLED, the 32500 sends
data only when it receives a polling command that contains the
unique address of the unit being polled. The command for polling is:
Ma!
where a = address character.
See the SERIAL FORMAT DIAGRAM for details on the data sent
from the 32500 when polled.
1.3 MAINTENANCE
Like all quality measuring instruments, the 32500 Electronic Com-
pass should be periodically recalibrated. The recalibration period de-
pends on the application but once per year is typical. The unit may
be sent to the factory or your distributor for recalibration. A copy of
the calibration procedure is available to qualified technicians.
In order to compensate for local magnetic conditions, the compass
calibration can take place only at the site where it is installed.
If the
installation is changed, the compass must be recalibrated for
the new conditions.
In addition to changing the actual installation,
local conditions may also change by the introduction of iron masses
or electrical machinery and thus warrant recalibration.
1.4 WARRANTY
This product is warranted to be free of defects in materials and con-
struction for a period of 12 months from date of initial purchase. Li-
ability is limited to repair or replacement of defective item. A copy of
the warranty policy may be obtained from R. M. Young Company.
CE COMPLIANCE
This product has been tested and shown to comply with European
CE requirements for the EMC Directive. Please note that shielded
cable must be used.
Declaration of Conformity
Application of Council Directives:
89/336/EEC
Standards to which
Conformity is Declared:
EN 50081-1
EN 55022 (CISPR 22 class A)
EN 50082-1 (IEC 801-2, 3, 4)
Manufacturer's Name and Address:
R. M. Young Company
Traverse City, MI, 49686, USA
Importer's Name and Address:
See Shipper or Invoice
Type of Equipment:
Meteorological Instruments
Model Number / Year of Manufacture:
32400/32500/2000
I, the undersigned, hereby declare that the equipment
specified conforms to the above Directives and Standards.
Date / Place:
Traverse City, Michigan, USA September 1, 2000
David Poinsett
R & D Manager, R. M. Young Company
